Differences

This shows you the differences between two versions of the page.

--- mycnc:mycnc_et10 [2019/02/10 20:16] – skirillov
+++ mycnc:mycnc_et10 [2019/04/25 12:35] – ivan
@@ Line 66: / Line 66: @@
 <code>Jumpers are open.</code>
-{{hardware:et10:et10-connection-inputs-002-key-05-npn.jpg}}
+{{:hardware:et10:et10-connection-inputs-002-key-05-npn-02.jpg}}
@@ Line 73: / Line 73: @@
 <code>Jumpers are open.</code>
-{{hardware:et10:et10-connection-inputs-002-key-06-pnp.jpg}}
+{{:hardware:et10:et10-connection-inputs-002-key-06-pnp-03.jpg}}
@@ Line 79: / Line 79: @@
   * Internal power supply <code>Jumpers for selected group are  closed.</code> {{hardware:et10:et10-connection-inputs-002-key-03.jpg}} \\ \\ Common wire for 4 optocoupler units is connected to internal GND (0V) if the Jumper is closed. A switch should short another optocoupler input to +24V to activate input pin. \\ \\ Jumper should be closed to connect the optocoupler pin to +24V. A switch should short wire to GND(0V).
-  * External power supply (#1) <code>JUPMERS ARE OPEN</code> {{hardware:et10:et10-connection-inputs-002-key-01.jpg}}
+  * External power supply (#1) <code>JUPMERS ARE OPEN</code> {{:hardware:et10:et10-connection-inputs-002-key-01-02.jpg}}
-  * External power supply (#2) <code>JUPMERS ARE OPEN</code> {{hardware:et10:et10-connection-inputs-002-key-02.jpg}}
+  * External power supply (#2) <code>JUPMERS ARE OPEN</code> {{:hardware:et10:et10-connection-inputs-002-key-02-02.jpg}}