Differences

This shows you the differences between two versions of the page.

--- mycnc:mycnc_et10 [2019/06/14 13:38] – ivan
+++ mycnc:mycnc_et10 [2019/06/27 14:00] – ivan
@@ Line 168: / Line 168: @@
 {{hardware:et10bb-dimension.png}}
+==== ET10 Firmware Reflash ====
+To reflash the board
+. Unplug 24V DC power supply and detach ET10 controller from Breakout board
+. Plug 24V DC supply
+. Short power cable between ET1 and Breakout leave connected.
+. Plugin mini-USB cable to ET10 & Host Computer with myCNC installed
+. Close jumpers J4(reset) & J5)programming) on myCNC controller board
+. Open(remove) J4(reset) jumper.
+. Open myCNC software on Host computer, then go to Settings >  Support Tab
+. "Select board" set to "myCNC-ET10"
+. Select "Firmware version" from "Release", "Night build" or "Testing"
+. "UART port" select port with FT232 attached
+. Baud Rate set to "115200" for ET10; other baudrate can be selected in case of problems on 115200 speed
+. Press "Update Firmware" button, Firmware download and reflashing process will be started.
+. Sector 0 will be written at the end of process, so message in debug window "Sector 0; +" means reflashing process finished successfully.
+. Remove all jumpers (J4, J5), assemble TE10 and Breakout and restart the board.
+If reflashing process failed, please repeat sequence from Step 5.