Differences

This shows you the differences between two versions of the page.

--- mycnc:mycnc_et10 [2019/06/27 14:00] – ivan
+++ mycnc:mycnc_et10 [2019/06/27 14:01] – ivan
@@ Line 174: / Line 174: @@
 . Unplug 24V DC power supply and detach ET10 controller from Breakout board
 . Plug 24V DC supply
 . Short power cable between ET1 and Breakout leave connected.
 . Plugin mini-USB cable to ET10 & Host Computer with myCNC installed
 . Close jumpers J4(reset) & J5)programming) on myCNC controller board
 . Open(remove) J4(reset) jumper.
 . Open myCNC software on Host computer, then go to Settings >  Support Tab
 . "Select board" set to "myCNC-ET10"
 . Select "Firmware version" from "Release", "Night build" or "Testing"
 . "UART port" select port with FT232 attached
 . Baud Rate set to "115200" for ET10; other baudrate can be selected in case of problems on 115200 speed
 . Press "Update Firmware" button, Firmware download and reflashing process will be started.
-. Sector 0 will be written at the end of process, so message in debug window "Sector 0; +" means reflashing process finished successfully.
+. Sector 0 will be written at the end of process, so message in debug window "Sector 0; +" means reflashing process finished
+successfully.
 . Remove all jumpers (J4, J5), assemble TE10 and Breakout and restart the board.