mycnc:mycnc_et10
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| mycnc:mycnc_et10 [2019/06/27 14:01] – ivan | mycnc:mycnc_et10 [2019/06/28 14:03] – ivan | ||
|---|---|---|---|
| Line 171: | Line 171: | ||
| ==== ET10 Firmware Reflash ==== | ==== ET10 Firmware Reflash ==== | ||
| + | |||
| + | |||
| To reflash the board | To reflash the board | ||
| - | 1. Unplug 24V DC power supply and detach ET10 controller from Breakout board | + | {{: |
| + | |||
| + | 1. Unplug | ||
| 2. Plug 24V DC supply | 2. Plug 24V DC supply | ||
| Line 179: | Line 183: | ||
| 3. Short power cable between ET1 and Breakout leave connected. | 3. Short power cable between ET1 and Breakout leave connected. | ||
| - | 4. Plugin | + | 4. Plug in the mini-USB cable to ET10 & Host Computer with myCNC installed |
| 5. Close jumpers J4(reset) & J5)programming) on myCNC controller board | 5. Close jumpers J4(reset) & J5)programming) on myCNC controller board | ||
mycnc/mycnc_et10.txt · Last modified: 2023/10/25 12:59 by ivan