Differences

This shows you the differences between two versions of the page.

--- mycnc:mycnc_et10 [2019/06/28 14:03] – ivan
+++ mycnc:mycnc_et10 [2019/09/23 09:24] – ivan
@@ Line 175: / Line 175: @@
 To reflash the board
-{{:mycnc:et10-firmware-reflash-002.jpg}}
+{{:mycnc:et10-firmware-reflash-003.jpg}}
-. Unplug the  24V DC power supply and detach the ET10 controller from the Breakout board
+. Unplug the 24V DC power supply and detach the ET10 controller from the Breakout board
 . Plug 24V DC supply
@@ Line 185: / Line 185: @@
 . Plug in the mini-USB cable to ET10 & Host Computer with myCNC installed
-. Close jumpers J4(reset) & J5)programming) on myCNC controller board
+. Close jumpers J4(reset) & J5 (programming) on the myCNC controller board
-. Open(remove) J4(reset) jumper.
+. Open (remove) the J4(reset) jumper.
-. Open myCNC software on Host computer, then go to Settings >  Support Tab
+. Open myCNC software on the Host computer, then go to Settings >  Support Tab
 . "Select board" set to "myCNC-ET10"
@@ Line 197: / Line 197: @@
 . "UART port" select port with FT232 attached
-. Baud Rate set to "115200" for ET10; other baudrate can be selected in case of problems on 115200 speed
+. Baud Rate set to "115200" for ET10; other baudrate can be selected in case of issues with the 115200 speed
-. Press "Update Firmware" button, Firmware download and reflashing process will be started.
+. Press "Update Firmware" button, Firmware download and the reflashing process will be started.
-. Sector 0 will be written at the end of process, so message in debug window "Sector 0; +" means reflashing process finished
+. Sector 0 will be written at the end of process, so message in debug window "Sector 0; +" means reflashing process was completed successfully.
-successfully.
 . Remove all jumpers (J4, J5), assemble TE10 and Breakout and restart the board.
-If reflashing process failed, please repeat sequence from Step 5.
+If the reflashing process has failed, please repeat the process from Step 5.