mycnc:mycnc_et10
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:mycnc_et10 [2020/01/27 10:32] – ivan | mycnc:mycnc_et10 [2020/09/10 13:16] – skirillov | ||
---|---|---|---|
Line 1: | Line 1: | ||
==== myCNC-ET10 CNC controller ==== | ==== myCNC-ET10 CNC controller ==== | ||
+ | |||
+ | Controller specifications: | ||
+ | * 6 channels pulse/dir outputs; | ||
+ | * 6 channels +/-10V DAC outputs for analogue servo-driver control; | ||
+ | * 6 channels incremental encoders inpiuts, 4 full ABC encoder inputs, 2 reduced AB encoder inputs; | ||
+ | * 48 binary inputs (if use with ET10BB breakout - all inputs have galvanic isolation, 12 groups of 4 binary inputs, compatible with NPN & PNP sensors); | ||
+ | * 24 binary outputs (if use with ET10BB breakout - all outputs are open collector, 24V 0.25A); | ||
+ | * 4 PWM outputs (if use with ET10BB breakout - all PWM outputs are open collector, 24V 0.25A); | ||
+ | * 8 ADC inputs (if use with ET10BB breakout - 7 ADC inputs are 0...5V range, 1 ADC is differential inpit, 0...30V range); | ||
+ | |||
==== Power supply connection ==== | ==== Power supply connection ==== | ||
Line 26: | Line 36: | ||
==== ET10 Output pins ==== | ==== ET10 Output pins ==== | ||
- | ET15 board contains 28 output pins- | + | ET10 board contains 28 output pins- |
* 24 open collector outputs (OUT#0 ... OUT#23) | * 24 open collector outputs (OUT#0 ... OUT#23) | ||
* 4 PWM outputs (PWM#1, PWM#2, PWM#3, PWM#4) | * 4 PWM outputs (PWM#1, PWM#2, PWM#3, PWM#4) | ||
Line 143: | Line 153: | ||
{{: | {{: | ||
+ | |||
+ | |||
+ | ET10 breakout, Revision 3 (2020) | ||
+ | |||
+ | {{hardware: | ||
+ | |||
+ | {{hardware: | ||
+ | |||
+ | |||
Line 148: | Line 167: | ||
MyCNC-Et10 control board has a RS485 bus connector. Modbus ASCII/RTU and Hypertherm Serial communication interfaces are implemented in myCNC-ET10 control board. | MyCNC-Et10 control board has a RS485 bus connector. Modbus ASCII/RTU and Hypertherm Serial communication interfaces are implemented in myCNC-ET10 control board. | ||
+ | |||
+ | //Note that channel #0 is reserved for special purpose applications. Please contact the myCNC development team to implement a special user case. Channel #1 can be used freely by the end user.// | ||
+ | |||
RS485 connector pinout is shown below: | RS485 connector pinout is shown below: | ||
mycnc/mycnc_et10.txt · Last modified: 2023/10/25 12:59 by ivan