Differences

This shows you the differences between two versions of the page.

--- mycnc:mycnc_et10 [2020/01/27 10:32] – ivan
+++ mycnc:mycnc_et10 [2020/09/10 15:27] – ivan
@@ Line 1: / Line 1: @@
 ==== myCNC-ET10 CNC controller ====
+Controller specifications:
+  * 6 channels pulse/dir outputs;
+  * 6 channels +/-10V DAC outputs for analogue servo-driver control;
+  * 6 channels incremental encoders inpiuts, 4 full ABC encoder inputs, 2 reduced AB encoder inputs;
+  * 48 binary inputs (if use with ET10BB breakout - all inputs have galvanic isolation, 12 groups of 4 binary inputs, compatible with NPN & PNP sensors);
+  * 24 binary outputs (if use with ET10BB breakout - all outputs are open collector, 24V 0.25A);
+  * 4 PWM outputs (if use with ET10BB breakout - all PWM outputs are open collector, 24V 0.25A);
+  * 8 ADC inputs (if use with ET10BB breakout - 7 ADC inputs are 0...5V range, 1 ADC is differential inpit, 0...30V range);
 ==== Power supply connection ====
@@ Line 26: / Line 36: @@
 ==== ET10 Output pins ====
-ET15 board contains 28 output pins-
+ET10 board contains 28 output pins-
   * 24 open collector outputs (OUT#0 ... OUT#23)
   * 4 PWM outputs (PWM#1, PWM#2, PWM#3, PWM#4)
@@ Line 143: / Line 153: @@
 {{:hardware:et10:et10-potentiometer-001.jpg}}
+ET10 breakout, Revision 3 (2020)
+{{hardware:et10:et10-r3-iso-adc.png}}
+{{hardware:et10:et10-r3-connection-adc-001.jpg}}
+Revision 3 of the ET10 breakout board is now available to buy through our [[https://shop.pv-automation.com/|Online Store]].
+The new revision of the breakout board is now compatible with both the ET10 and the ET15 (as an option instead of the native ET15 breakout board).
+Galvanic isolation on the ADC has been added (highly useful for plasma cutting applications). The new ADC configuration is as follows:
+^ ADC Port ^ Number of ports ^
+| Conventional | 6 |
+| Differential (30V) | 1 |
+| Differential with galvanic isolation (0-5V) | 1 |
@@ Line 148: / Line 177: @@
 MyCNC-Et10 control board has a RS485 bus connector. Modbus ASCII/RTU and Hypertherm Serial communication interfaces are implemented in myCNC-ET10 control board.
+//Note that channel #0 is reserved for special purpose applications. Please contact the myCNC development team to implement a special user case. Channel #1 can be used freely by the end user.//
 RS485 connector pinout is shown below: