User Tools

Site Tools


mycnc:mycnc_et10

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
mycnc:mycnc_et10 [2019/06/14 13:38]
ivan
mycnc:mycnc_et10 [2019/06/28 14:03] (current)
ivan
Line 168: Line 168:
  
 {{hardware:​et10bb-dimension.png}} {{hardware:​et10bb-dimension.png}}
 +
 +
 +==== ET10 Firmware Reflash ====
 +
 +
 +To reflash the board
 +
 +{{:​mycnc:​et10-firmware-reflash-002.jpg}}
 +
 +1. Unplug the  24V DC power supply and detach the ET10 controller from the Breakout board
 +
 +2. Plug 24V DC supply
 +
 +3. Short power cable between ET1 and Breakout leave connected.
 +
 +4. Plug in the mini-USB cable to ET10 & Host Computer with myCNC installed
 +
 +5. Close jumpers J4(reset) & J5)programming) on myCNC controller board
 +
 +6. Open(remove) J4(reset) jumper.
 +
 +7. Open myCNC software on Host computer, then go to Settings >  Support Tab
 +
 +8. "​Select board" set to "​myCNC-ET10"​
 +
 +9. Select "​Firmware version"​ from "​Release",​ "Night build" or "​Testing"​
 +
 +10. "UART port" select port with FT232 attached
 +
 +11. Baud Rate set to "​115200"​ for ET10; other baudrate can be selected in case of problems on 115200 speed
 +
 +12. Press "​Update Firmware"​ button, Firmware download and reflashing process will be started.
 +
 +13. Sector 0 will be written at the end of process, so message in debug window "​Sector 0; +" means reflashing process finished ​
 +successfully.
 +
 +14. Remove all jumpers (J4, J5), assemble TE10 and Breakout and restart the board.
 +
 +If reflashing process failed, please repeat sequence from Step 5.
  
  
mycnc/mycnc_et10.1560533926.txt.gz ยท Last modified: 2019/06/14 13:38 by ivan