mycnc:mycnc_et15
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:mycnc_et15 [2018/08/09 00:09] – skirillov | mycnc:mycnc_et15 [2019/09/19 11:27] – ivan | ||
---|---|---|---|
Line 8: | Line 8: | ||
Power Supply 24V DC and +24V and GND pins are shown in a picture below. | Power Supply 24V DC and +24V and GND pins are shown in a picture below. | ||
- | {{hardware:et15: | + | __NOTE: The board has a set of incorrectly labelled 5V pins (labeled on the board as 24V). Below is the correct power supply pinout:__ |
+ | {{: | ||
==== Pulse-Dir outputs ==== | ==== Pulse-Dir outputs ==== |
mycnc/mycnc_et15.txt · Last modified: 2022/01/28 11:21 by ivan