Differences

This shows you the differences between two versions of the page.

--- mycnc:mycnc_et15 [2019/09/16 15:27] – ivan
+++ mycnc:mycnc_et15 [2019/09/19 12:15] – ivan
@@ Line 8: / Line 8: @@
 Power Supply 24V DC and +24V and GND pins are shown in a picture below.
-NOTE: The board has a set of incorrectly labelled 5V pins (labeled on the board as 24V). Below is the correct power supply pinout:
+__NOTE: The board has a set of incorrectly labelled 5V pins (labeled on the board as 24V). Below is the correct power supply pinout:__
 {{:mycnc:et15-power-v2.jpg}}
@@ Line 23: / Line 23: @@
 PULSE-DIR channels 0,1,2,3 pinout
-{{hardware:et15:et15-connection-pulsedir-001.jpg}}
+{{:mycnc:et15-pulsedir-001-v2.jpg}}
 PULSE-DIR channels 4,5,6,7 pinout
-{{hardware:et15:et15-connection-pulsedir-002.jpg}}
+{{:mycnc:et15-pulsedir-002-v2.jpg}}
 ==== ET15 Output pins ====
@@ Line 55: / Line 55: @@
 Additional 2 groups (8 optocoupler inputs) are connected to 8 encoder inputs pins (ENCODER pins 5B, 5C, 6A, 6B,6C, 7A, 7B, 7C). Change SW1 position to select either galvanic isolated inputs or line driver inputs for INPUTS #64...#71.
+{{:mycnc:et15-inputs-001-v2.jpg}}
-{{hardware:et15:et15-connection-inputs-001.jpg}}
 ==== ET15 Encoder inputs ====
@@ Line 66: / Line 65: @@
 **ENCODERS** channels 0,1,2,3 pinout
-{{hardware:et15:et15-connection-encoders-001.jpg}}
+{{:mycnc:et15-encoders-001-v2.jpg}}
 **ENCODERS** channels 4,5,6,7 pinout
-{{hardware:et15:et15-connection-encoders-002.jpg}}
+{{:mycnc:et15-encoders-002-v2.jpg}}
@@ Line 95: / Line 94: @@
 A myCNC-ET15 control board has RS422/RS485 bus connector. Connector pinout for RS422, RS485 shown below
+{{:mycnc:et15-uart-001-v2.jpg}}
-{{hardware:et15:et15-connection-uart-001.jpg}}
 ==== Connection Examples ====