Differences

This shows you the differences between two versions of the page.

--- mycnc:mycnc_et6 [2022/03/28 09:14] – ivan
+++ mycnc:mycnc_et6 [2022/05/06 16:32] – ivan
@@ Line 10: / Line 10: @@
 | RS485/RS422 | 1x RS485 with Modbus ASCII/RTU implementation |
 | Computer connections | Ethernet (PC/ARM, Linux, MS Windows) |
+//Note: The ET8 board is the new updated version of the ET6 controller, which requires unique firmware due to the use of a different chip.//
 ==== ET6 Top View ====
@@ Line 139: / Line 141: @@
 ==== ET6 control board firmware reflash ====
-//**WARNING: Unlike updating the myCNC software, the firmware CANNOT be downgraded after a reflash. The myCNC team recommends reflashing the control board firmware as a last resort only, and recommends seeking an explicit confirmation that the firmware reflash is warranted from the support team to avoid issues.**//
+//**WARNING:** Unlike updating the myCNC software, the firmware CANNOT be downgraded after a reflash. The myCNC team recommends reflashing the control board firmware as a last resort only, and recommends seeking an explicit confirmation from the support team that the firmware reflash is warranted in order to avoid issues.//
 {{:mycnc:019-et6-reflash-001.jpg}}