User Tools

Site Tools


mycnc:mycnc_et6

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
mycnc:mycnc_et6 [2019/02/20 18:00] skirillovmycnc:mycnc_et6 [2019/02/20 18:02] skirillov
Line 7: Line 7:
 ==== Power supply connection ==== ==== Power supply connection ====
  
-24V DC is used to supply myCNC-ET control board. Power consumption depends on external peripherals you have connected to open collector outputs and +12V/+5V outputs. Normally power supply 24V/2A should be enough to power up the controlller based kit with single board computer and 15'6" TFT screen. However, step-down converters on the ET6 board have start current about 1.5A and 24V/1A power supply might be not enough to supply the single ET6 board.+24V DC is used to supply myCNC-ET6 control board. Power consumption depends on external peripherals you have connected to open collector outputs and +12V/+5V outputs. Normally power supply 24V/2A should be enough to power up the controller based kit with single board computer and 15'6" TFT screen. However, step-down converters on the ET6 board consume start current about 1.5A and 24V/1A power supply might be not enough to supply the single ET6 board.
  
 {{hardware:et6:et6-power-connection-001.jpg}} {{hardware:et6:et6-power-connection-001.jpg}}
Line 137: Line 137:
   - Press "Update Firmware" button, Firmware download and reflashing process will be started.{{hardware:et6:mycnc-et6-reflash-003.png}}   - Press "Update Firmware" button, Firmware download and reflashing process will be started.{{hardware:et6:mycnc-et6-reflash-003.png}}
   - Sector 0 will be written at the end of process. After firmware process finished, a popup message will be shown. {{hardware:et6:mycnc-et6-reflash-004.png}}   - Sector 0 will be written at the end of process. After firmware process finished, a popup message will be shown. {{hardware:et6:mycnc-et6-reflash-004.png}}
-  - Remove all jumpers (J5, J5) and restart the board. To restart the board you need \\ either repower ET6 or \\ close Reset jumper (J5) for 1 second, then release it. The board will be restarted.+  - Remove all jumpers (J5, J6) and restart the board. To restart the board you need \\ either repower ET6 or \\ close Reset jumper (J5) for 1 second, then release it. The board will be restarted.
  
 In case reflashing process failed, you get a popup message. {{hardware:et6:mycnc-et6-reflash-005.png}} Please repeat procedure from #3 In case reflashing process failed, you get a popup message. {{hardware:et6:mycnc-et6-reflash-005.png}} Please repeat procedure from #3
mycnc/mycnc_et6.txt · Last modified: 2023/03/16 09:23 by ivan

Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki