mycnc:mycnc_et7
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:mycnc_et7 [2019/06/10 12:33] – ivan | mycnc:mycnc_et7 [2019/06/10 14:02] – ivan | ||
---|---|---|---|
Line 188: | Line 188: | ||
{{: | {{: | ||
- | === Switch connection example === | + | As the sensor requires a 24V power supply, it is necessary to connect it to the 24V port, not the 5V. |
+ | |||
+ | === Switch connection example | ||
< | < | ||
Line 199: | Line 201: | ||
{{: | {{: | ||
+ | |||
+ | ===Switch connection example (external power supply)=== | ||
+ | |||
+ | {{: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | < | ||
=== Spindle Speed control over DAC (0-10V) output === | === Spindle Speed control over DAC (0-10V) output === |