mycnc:mycnc_et7
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:mycnc_et7 [2019/06/10 14:02] – ivan | mycnc:mycnc_et7 [2019/06/14 12:57] – ivan | ||
---|---|---|---|
Line 161: | Line 161: | ||
==== Connection Examples ==== | ==== Connection Examples ==== | ||
- | === 3-wire NPN sensor connection example === | + | === 3-wire NPN sensor connection example |
< | < | ||
- | {{:hardware: | + | {{:mycnc:et7-npn-external-001-v2.png}} |
- | + | === 3-wire PNP sensor connection example | |
- | === 3-wire PNP sensor connection example === | + | |
< | < | ||
- | + | {{:mycnc:et7-pnp-external-001-v2.png}} | |
- | {{:hardware: | + | |
{{hardware: | {{hardware: | ||
Line 179: | Line 176: | ||
One of jumpers J1,J2,J3,J4 (J4 in case of this example) is closed.</ | One of jumpers J1,J2,J3,J4 (J4 in case of this example) is closed.</ | ||
- | {{: | + | {{: |
=== 3-wire PNP sensor connection example (internal power supply)=== | === 3-wire PNP sensor connection example (internal power supply)=== | ||
Line 186: | Line 183: | ||
All of jumpers J1,J2,J3,J4 are open.</ | All of jumpers J1,J2,J3,J4 are open.</ | ||
- | {{: | + | {{: |
As the sensor requires a 24V power supply, it is necessary to connect it to the 24V port, not the 5V. | As the sensor requires a 24V power supply, it is necessary to connect it to the 24V port, not the 5V. | ||
Line 200: | Line 197: | ||
Switch should also short the wire to GNC(0V). | Switch should also short the wire to GNC(0V). | ||
- | {{:hardware: | + | {{:mycnc: |
- | ===Switch connection example (external power supply) | + | ===Switch connection example (external power supply)=== |
- | {{: | + | {{: |
- | {{: | + | {{: |
< | < |
mycnc/mycnc_et7.txt · Last modified: 2024/02/28 15:29 by ivan