myCNC Online Documentation

User Tools

Site Tools

Trace:
mycnc:mycnc_et7

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
Next revisionBoth sides next revision
mycnc:mycnc_et7 [2019/06/27 13:17] – ivanmycnc:mycnc_et7 [2019/06/27 13:43] – ivan
Line 283: Line 283:
 To reflash the board: To reflash the board:
  
-  1. Plug in the 24V DC power supply +1. Plug in the 24V DC power supply 
-  2. Plug in the micro-USB cable into the ET7 controller & a Host Computer with myCNC installed + 
-  3. Close jumpers J5(reset) & J6(programming) on the controller board +2. Plug in the micro-USB cable into the ET7 controller & a Host Computer with myCNC installed 
-  4. Open (remove) the J5 jumper.+ 
 +3. Close jumpers J5(reset) & J6(programming) on the controller board 
 + 
 +4. Open (remove) the J5 jumper.
  
 {{:mycnc:et7-reflash-001.png}} {{:mycnc:et7-reflash-001.png}}
  
-  5. Open myCNC software on Host computer (Settings > Support Tab) +5. Open myCNC software on Host computer (Settings > Support Tab)
-  6. "Select board" set to "myCNC-ET7" +
-  7. Select "Firmware version" from "Release", "Night build" or "Testing" +
-  8. "UART port" select port with FT232 attached +
-  9. Baud Rate set to "115200" for ET7; other baudrate can be selected in case of problems on 115200 speed +
-  10. Press "Update Firmware" button, Firmware download and reflashing process will be started. +
-  11. If "Sector 0; +" message is shown in the debug window, the reflashing process has finished successfully. +
-  12. Remove all jumpers (J4, J5) and restart the board.+
  
-If the reflashing process failed, please repeat the procedure from Step 3. +6. "Select board" set to "myCNC-ET7"
-   +
-{{:mycnc:et7-reflash-002-support.png}}+
  
 +7. Select "Firmware version" from "Release", "Night build" or "Testing" ("Release" is recommended)
  
 +8. "UART port" - select the port with FT232 attached. If no such port visible, check the micro-USB connection, then close and open the Support tab once again in order to refresh it. 
  
 +9. Baud Rate set to "115200" for ET7; other baudrate can be selected in case of problems on the 115200 speed
 +
 +10. Press "Update Firmware" button, Firmware download and reflashing process will be started
 +
 +11. If "Sector 0; +" message is shown in the debug window, the reflashing process has been finished successfully.
 +
 +12. Remove all jumpers (J4, J5) and restart the board.
 +  
 +{{:mycnc:et7-reflash-002-support.png}}
 +
 +If the reflashing process failed, please repeat the procedure from Step 3.
Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki