mycnc:mycnc_et7
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:mycnc_et7 [2019/06/27 13:17] – ivan | mycnc:mycnc_et7 [2019/09/20 12:26] – ivan | ||
---|---|---|---|
Line 148: | Line 148: | ||
{{hardware: | {{hardware: | ||
- | RS422 connector pinout shown below | + | RS422 connector pinout shown below. **NOTE**: While all of the RX/TX ports (RX A, RX B, TX A, TX B) are used for the RS422 connection (such as a Hypertherm machine), only RX A and RX B are utilized in an RS485 configuration. |
- | {{:hardware: | + | |
+ | {{:mycnc: | ||
==== DAC output ==== | ==== DAC output ==== | ||
Line 161: | Line 163: | ||
==== Connection Examples ==== | ==== Connection Examples ==== | ||
+ | |||
+ | ===Stepper driver connection (4 axes)=== | ||
+ | |||
+ | {{: | ||
+ | |||
=== 3-wire NPN sensor connection example (external power supply)=== | === 3-wire NPN sensor connection example (external power supply)=== | ||
Line 283: | Line 290: | ||
To reflash the board: | To reflash the board: | ||
- | | + | 1. Plug in the 24V DC power supply |
- | 2. Plug in the micro-USB cable into the ET7 controller & a Host Computer with myCNC installed | + | |
- | 3. Close jumpers J5(reset) & J6(programming) on the controller board | + | 2. Plug in the micro-USB cable into the ET7 controller & a Host Computer with myCNC installed |
- | 4. Open (remove) the J5 jumper. | + | |
+ | 3. Close jumpers J5(reset) & J6(programming) on the controller board | ||
+ | |||
+ | 4. Open (remove) the J5 jumper. | ||
{{: | {{: | ||
- | | + | 5. Open myCNC software on Host computer (Settings > Support Tab) |
- | 6. " | + | |
- | 7. Select " | + | |
- | 8. "UART port" select port with FT232 attached | + | |
- | 9. Baud Rate set to " | + | |
- | 10. Press " | + | |
- | 11. If " | + | |
- | 12. Remove all jumpers (J4, J5) and restart the board. | + | |
- | If the reflashing process | + | 6. " |
+ | |||
+ | 7. Select " | ||
+ | |||
+ | 8. "UART port" - select the port with FT232 attached. | ||
+ | |||
+ | 9. Baud Rate set to " | ||
+ | |||
+ | 10. Press " | ||
+ | |||
+ | 11. If " | ||
+ | |||
+ | 12. Remove all jumpers (J4, J5) and restart the board. | ||
| | ||
{{: | {{: | ||
+ | {{: | ||
+ | If the reflashing process failed, please check your internet connection and the micro-USB connection, and then repeat the reflashing procedure from Step 3. |