Differences

This shows you the differences between two versions of the page.

--- mycnc:mycnc_et7 [2019/06/27 13:20] – ivan
+++ mycnc:mycnc_et7 [2019/06/27 13:43] – ivan
@@ Line 299: / Line 299: @@
 . Select "Firmware version" from "Release", "Night build" or "Testing" ("Release" is recommended)
-. "UART port" select port with FT232 attached
+. "UART port" - select the port with FT232 attached. If no such port visible, check the micro-USB connection, then close and open the Support tab once again in order to refresh it.
-. Baud Rate set to "115200" for ET7; other baudrate can be selected in case of problems on 115200 speed
+. Baud Rate set to "115200" for ET7; other baudrate can be selected in case of problems on the 115200 speed
 . Press "Update Firmware" button, Firmware download and reflashing process will be started
-. If "Sector 0; +" message is shown in the debug window, the reflashing process has finished successfully.
+. If "Sector 0; +" message is shown in the debug window, the reflashing process has been finished successfully.
 . Remove all jumpers (J4, J5) and restart the board.