mycnc:mycnc_et7
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:mycnc_et7 [2019/06/27 13:20] – ivan | mycnc:mycnc_et7 [2019/06/27 13:55] – ivan | ||
---|---|---|---|
Line 299: | Line 299: | ||
7. Select " | 7. Select " | ||
- | 8. "UART port" select port with FT232 attached | + | 8. "UART port" |
- | 9. Baud Rate set to " | + | 9. Baud Rate set to " |
10. Press " | 10. Press " | ||
- | 11. If " | + | 11. If " |
12. Remove all jumpers (J4, J5) and restart the board. | 12. Remove all jumpers (J4, J5) and restart the board. | ||
Line 311: | Line 311: | ||
{{: | {{: | ||
- | If the reflashing process failed, please repeat the procedure from Step 3. | + | {{: |
+ | |||
+ | If the reflashing process failed, please |