Differences

This shows you the differences between two versions of the page.

--- mycnc:mycnc_et7 [2019/06/27 13:43] – ivan
+++ mycnc:mycnc_et7 [2019/09/12 10:36] – ivan
@@ Line 148: / Line 148: @@
 {{hardware:et7:et7-rs485.png}}
-RS422 connector pinout shown below
+RS422 connector pinout shown below. **NOTE**: While all of the RX/TX ports (RX A, RX B, TX A, TX B) are used for the RS422 connection (such as a Hypertherm machine), only RX A and RX B are utilized in an RS485 configuration.
-{{:hardware:et7:et7-b-rs422-connection-001.jpg}}
+{{:mycnc:et7-b-rs422-connection-002-rs485-connections.jpg}}
 ==== DAC output ====
@@ Line 311: / Line 313: @@
 {{:mycnc:et7-reflash-002-support.png}}
-If the reflashing process failed, please repeat the procedure from Step 3.
+{{:mycnc:et7-reflash-004-success.png}}
+If the reflashing process failed, please check your internet connection and the micro-USB connection, and then repeat the reflashing procedure from Step 3.