Differences

This shows you the differences between two versions of the page.

--- mycnc:mycnc_et7 [2020/04/27 12:00] – ivan
+++ mycnc:mycnc_et7 [2021/04/05 12:09] – ivan
@@ Line 12: / Line 12: @@
 | DAC output | 1x - 0...10V (for spindle speed control and relative applications)|
 | RS485/RS422 | 1x RS422 full duplex serial communication OR 2x RS485 half-duplex serial communication |
-| External operator panel connector | up to 25 external keys,  up to 2 rotary encodersup to 2 double-axes joysticks OR
+| External operator panel connector | up to 25 external keys,  up to 2 rotary encodersup to 2 double-axes joysticks OR up to 4 potentiometers (shared with 4x ADC inputs) |
-up to 4 potentiometers (shared with 4x ADC inputs) |
 | Power supply outputs for control computer | 2x DC-DC converters 5V 1.5A |
@@ Line 25: / Line 24: @@
 Power Supply 24V DC and +24V and GND pins are shown on a picture below.
-{{hardware:et7:et7-power-connection-001.jpg}}
+{{:mycnc:et7-power-connection-003.jpg}}
+//NOTE: Depending on the board revision version, the +5/+5V power supply in the top left corner may actually be
+a +5/+12V power supply (on older boards).//
 ==== Pulse-Dir outputs ====
@@ Line 111: / Line 112: @@
 {{hardware:et7:et7-encoder-inputs.png}}
-Encoder inputs connector pinout is shown on a picture
+Encoder inputs connector pinout is shown in the diagram below:
-{{hardware:et7:et7-encoder-inputs-connection-001.jpg}}
+{{:mycnc:et7-encoder-inputs-connection-003.jpg}}
+//NOTE: Depending on the board revision version, the +5/+5V power supply in the top left corner may actually be
+a +5/+12V power supply (on older boards).//