mycnc:mycnc_et7
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
mycnc:mycnc_et7 [2020/04/27 12:00] – ivan | mycnc:mycnc_et7 [2021/04/05 12:09] – ivan | ||
---|---|---|---|
Line 24: | Line 24: | ||
Power Supply 24V DC and +24V and GND pins are shown on a picture below. | Power Supply 24V DC and +24V and GND pins are shown on a picture below. | ||
- | {{hardware:et7: | + | {{:mycnc: |
+ | //NOTE: Depending on the board revision version, the +5/+5V power supply in the top left corner may actually be | ||
+ | a +5/+12V power supply (on older boards).// | ||
==== Pulse-Dir outputs ==== | ==== Pulse-Dir outputs ==== | ||
Line 110: | Line 112: | ||
{{hardware: | {{hardware: | ||
- | Encoder inputs connector pinout is shown on a picture | + | Encoder inputs connector pinout is shown in the diagram below: |
- | {{hardware:et7: | + | {{:mycnc: |
+ | |||
+ | //NOTE: Depending on the board revision version, the +5/+5V power supply in the top left corner may actually be | ||
+ | a +5/+12V power supply (on older boards).// | ||