mycnc:mycnc_hardware
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:mycnc_hardware [2017/09/04 12:16] – skirillov | mycnc:mycnc_hardware [2018/02/07 00:56] – skirillov | ||
---|---|---|---|
Line 10: | Line 10: | ||
[[Change IP address of Single Board Computer (SBC)]] | [[Change IP address of Single Board Computer (SBC)]] | ||
+ | |||
+ | [[Change Screen Resolution for Single Board Computer (SBC)]] | ||
+ | |||
+ | [[Teamviewer Reset Config]] | ||
+ | |||
[[Open collector outputs and PWM outputs schematic design]] | [[Open collector outputs and PWM outputs schematic design]] | ||
+ | |||
+ | [[Rotary encoder connection and setup]] | ||
+ | |||
mycnc/mycnc_hardware.txt · Last modified: 2024/04/02 12:43 by ivan