mycnc:mycnc_pulse_width_setup
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:mycnc_pulse_width_setup [2020/11/26 10:02] – ivan | mycnc:mycnc_pulse_width_setup [2020/11/26 15:17] – ivan | ||
---|---|---|---|
Line 65: | Line 65: | ||
{{: | {{: | ||
*The 12 μs corresponds to Setting 7 in the chart, thus the **Pulse width** value should be set to 7 in myCNC software. | *The 12 μs corresponds to Setting 7 in the chart, thus the **Pulse width** value should be set to 7 in myCNC software. | ||
- | | + | |
+ | * for ЕТ6, ЕТ7 controllers - **value 1** is for the first 4 motor outputs, **value 2** is for the next 2 motor outputs | ||
+ | * for ЕТ10 - all channels are equal (use **only value 1**, values 2 and 3 are not used) | ||
+ | * for ЕТ15 - **value 1** is for the first 4 motor outputs, **value 2** is for the next 2 motor outputs, **value 3** is for the last 2 motor outputs | ||
{{: | {{: | ||
*The pulse width setup is now complete. | *The pulse width setup is now complete. |
mycnc/mycnc_pulse_width_setup.txt · Last modified: 2024/01/22 11:05 by ivan