Differences

This shows you the differences between two versions of the page.

--- mycnc:mycnc_rotate_widget [2019/10/31 11:27] – ivan
+++ mycnc:mycnc_rotate_widget [2019/10/31 12:04] – ivan
@@ Line 29: / Line 29: @@
 //Set the first point. Position the plasma torch at the lower left corner of the sheet. The point is recorded by pressing the "1" button. Movement is done with the arrows at the center of the screen.//
-{{:mycnc:rotate_2.png?1000|}}
+{{:mycnc:rotation-widget-014.png}}
 //Next, move the plasma torch along the sheet (the longer the distance of this movement, the more accurate the correction will be). We bring the plasma torch to the edge of the sheet after moving along it. We assign this second point by pressing the "2" button. Movement is done with the arrows at the center of the screen.//
-{{:mycnc:rotate_3.png?1000|}}
+{{:mycnc:rotation-widget-015.png}}
 //After clicking on the "Apply Correction" button, you must confirm the program conversion in the popup window (press the check mark icon).//
-{{:mycnc:rotate_4.png?1000|}}
+{{:mycnc:rotation-widget-016.png}}
 //After the confirmation button has been pressed, the correction will be displayed on the screen. To use this corrected program file, it is now necessary to press the Send button to display the altered nesting map in the main program window.//
-{{:mycnc:rotate_5.png?1000|}}
+{{:mycnc:rotation-widget-017.png}}
 **//Rotation of the nesting map to a previously used angle//**
 //Select the rotation angle from the list of previously used values//
-{{:mycnc:rotate_8.png?1000|}}
+{{:mycnc:rotation-widget-018.png}}
 //Confirm or cancel the rotation//
-{{:mycnc:rotate_9.png?1000|}}
+{{:mycnc:rotation-widget-019.png}}
 //After the changes have been applied, it is necessary to press the Send button to display the rotated nesting map in the main program window so that .//
-{{:mycnc:rotate_10.png?1000|}}
+{{:mycnc:rotation-widget-020.png}}