mycnc:mycnc_setup_examples:plasma_cutting:1366p
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
mycnc:mycnc_setup_examples:plasma_cutting:1366p [2019/10/10 11:15] – ivan | mycnc:mycnc_setup_examples:plasma_cutting:1366p [2020/11/11 11:49] – ivan | ||
---|---|---|---|
Line 47: | Line 47: | ||
|{{: | |{{: | ||
|{{: | |{{: | ||
- | |{{: | + | |{{: |
|{{: | |{{: | ||
- | |{{: | + | |{{: |
|{{: | |{{: | ||
Line 56: | Line 56: | ||
|{{: | |{{: | ||
|{{: | |{{: | ||
- | |{{: | + | |{{: |
====G-code tab (Part selection and editing)==== | ====G-code tab (Part selection and editing)==== | ||
Line 72: | Line 72: | ||
This screen presents the user with the options and indicators for the plasma controls. The five buttons on the right side of the tab are the most commonly used: | This screen presents the user with the options and indicators for the plasma controls. The five buttons on the right side of the tab are the most commonly used: | ||
- | | {{: | + | |{{: |
- | | {{: | + | |{{: |
- | | {{: | + | |{{: |
- | | {{: | + | |{{: |
- | | {{: | + | |{{: |
Line 113: | Line 113: | ||
{{: | {{: | ||
- | ====Simulation mode - ignore cutting commands==== | + | ====Simulation mode (Trial mode) ==== |
With the simulation mode turned ON, the software will ignore the cutting commands, simply moving the working bit (plasma torch, laser pointer, etc) around to give the user an option of running the program before the actual cutting begins. The commands which the myCNC software will ignore can be specified in the **Settings > Config > Preferences > Start/ | With the simulation mode turned ON, the software will ignore the cutting commands, simply moving the working bit (plasma torch, laser pointer, etc) around to give the user an option of running the program before the actual cutting begins. The commands which the myCNC software will ignore can be specified in the **Settings > Config > Preferences > Start/ | ||
{{: | {{: |
mycnc/mycnc_setup_examples/plasma_cutting/1366p.txt · Last modified: 2020/11/11 11:49 by ivan