mycnc:mycnc_setup_examples
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| mycnc:mycnc_setup_examples [2021/02/05 16:05] – ivan | mycnc:mycnc_setup_examples [2021/02/05 16:06] – ivan | ||
|---|---|---|---|
| Line 396: | Line 396: | ||
| === Setting up a 2-motor X+Y X-Y 3D-printer=== | === Setting up a 2-motor X+Y X-Y 3D-printer=== | ||
| + | |||
| + | A 3D printer shown below is an example of a setup which utilized the X+Y and X-Y axis configuration in Settings -> Config -> Axes/ | ||
| http:// | http:// | ||
| + | http:// | ||
mycnc/mycnc_setup_examples.txt · Last modified: 2024/01/30 12:09 by ivan