mycnc:mycnc_setup_examples
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| mycnc:mycnc_setup_examples [2019/05/21 13:43] – ivan | mycnc:mycnc_setup_examples [2019/05/23 13:48] – ivan | ||
|---|---|---|---|
| Line 48: | Line 48: | ||
| ===How to set up a Probing Wizard in Mill profile=== | ===How to set up a Probing Wizard in Mill profile=== | ||
| - | In order to set up a mill profile from scratch on your machine (especially if the software has not, for any reason, been updated to its latest version) please check the following: | + | In order to properly |
| 1. In **CNC Settings > PLC > Hardware PLC**, check that the command **TRIG04** is created. The program should contain the following code: | 1. In **CNC Settings > PLC > Hardware PLC**, check that the command **TRIG04** is created. The program should contain the following code: | ||
mycnc/mycnc_setup_examples.txt · Last modified: 2024/01/30 12:09 by ivan