User Tools

Site Tools


mycnc:open_collector_outputs_and_pwm_outputs_schematic_design

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
mycnc:open_collector_outputs_and_pwm_outputs_schematic_design [2017/07/17 13:16]
skirillov
mycnc:open_collector_outputs_and_pwm_outputs_schematic_design [2017/07/17 13:16] (current)
skirillov
Line 10: Line 10:
  
 To test output pins load resistor should be connected between output pin and +24V. Oscilloscope diagrams for PWM are shown below -  To test output pins load resistor should be connected between output pin and +24V. Oscilloscope diagrams for PWM are shown below - 
-PWM=  20 {{hardware:​mycnc-pwm-output-0020.png}}+PWM =  20 {{hardware:​mycnc-pwm-output-0020.png}}
  
 PWM= 500 {{hardware:​mycnc-pwm-output-0500.png}} PWM= 500 {{hardware:​mycnc-pwm-output-0500.png}}
mycnc/open_collector_outputs_and_pwm_outputs_schematic_design.txt ยท Last modified: 2017/07/17 13:16 by skirillov