mycnc:rotary_encoder_connection_and_setup
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
mycnc:rotary_encoder_connection_and_setup [2018/08/10 21:38] – skirillov | mycnc:rotary_encoder_connection_and_setup [2018/08/10 21:38] – skirillov | ||
---|---|---|---|
Line 129: | Line 129: | ||
- Goto Diagnose widget and check binary input pins the encoder attached to are blinking while you turn the encoder. There are input pins #18, #19 on a picture {{hardware: | - Goto Diagnose widget and check binary input pins the encoder attached to are blinking while you turn the encoder. There are input pins #18, #19 on a picture {{hardware: | ||
- Check "Slow Encoder" | - Check "Slow Encoder" | ||
- | - Check Destination item value is changed while you turn the encoder.{{hardware: | + | - Check Destination item value is changed while you turn the encoder. |
+ | |||
+ | {{hardware: | ||
mycnc/rotary_encoder_connection_and_setup.txt · Last modified: 2022/03/22 13:49 by ivan