mycnc:rotary_encoder_connection_and_setup
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| mycnc:rotary_encoder_connection_and_setup [2019/08/01 13:03] – ivan | mycnc:rotary_encoder_connection_and_setup [2019/08/01 13:12] – ivan | ||
|---|---|---|---|
| Line 42: | Line 42: | ||
| Rotary encoders setup example is shown on a picture below | Rotary encoders setup example is shown on a picture below | ||
| - | {{hardware:et7:mycnc-configuration--74.png}} | + | {{:mycnc:items-004-mpg.png}} |
| - | + | There are 2 encoders attached on Inputs #0,1,2,3 and set up in the dialog. | |
| - | There are 2 encoders attached on Inputs #8,9,10,11 and set up in the dialog. | + | * Encoder #2 is attached to inputs #0 and #1 and used as a Pendant MPG/ |
| - | * Encoder #2 is attached to inputs #8 and #9 and used as a Pendant MPG/ | + | * Encoder #3 is attached to inputs #2 and #3 and used as a general purpose encoder. |
| - | * Encoder #3 is attached to inputs #10 and #11 and used as a general purpose encoder. | + | |
| For ET7 controller, Encoders #0 and #1 are connected to the X4 connector pins 11-14 (or through the ET7-KEY keyboard) and are configured despite being disabled in the myCNC settings window. | For ET7 controller, Encoders #0 and #1 are connected to the X4 connector pins 11-14 (or through the ET7-KEY keyboard) and are configured despite being disabled in the myCNC settings window. | ||
| Line 76: | Line 75: | ||
| To change Spindle speed, the XML Item " | To change Spindle speed, the XML Item " | ||
| - | {{hardware:et7:mycnc-profiles--43.png}} | + | {{:mycnc:calibrate-axes-003.png}} |
| A further selection of commonly used Items can be found in the [[mycnc: | A further selection of commonly used Items can be found in the [[mycnc: | ||
mycnc/rotary_encoder_connection_and_setup.txt · Last modified: 2022/03/22 13:49 by ivan