mycnc:rotary_encoder_connection_and_setup
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:rotary_encoder_connection_and_setup [2019/08/01 13:03] – ivan | mycnc:rotary_encoder_connection_and_setup [2019/08/01 13:27] – ivan | ||
---|---|---|---|
Line 5: | Line 5: | ||
{{hardware: | {{hardware: | ||
- | * Industrial style MPG with 100ppr and line driver 5V output{{hardware: | + | * Industrial style MPG with 100ppr and line driver 5V output |
Both types can be connected to myCNC controller and used the operator control panel. | Both types can be connected to myCNC controller and used the operator control panel. | ||
Line 42: | Line 42: | ||
Rotary encoders setup example is shown on a picture below | Rotary encoders setup example is shown on a picture below | ||
- | {{hardware:et7:mycnc-configuration--74.png}} | + | {{:mycnc:items-004-mpg.png}} |
- | + | There are 2 encoders attached on Inputs #0,1,2,3 and set up in the dialog. | |
- | There are 2 encoders attached on Inputs #8,9,10,11 and set up in the dialog. | + | * Encoder #2 is attached to inputs #0 and #1 and used as a Pendant MPG/ |
- | * Encoder #2 is attached to inputs #8 and #9 and used as a Pendant MPG/ | + | * Encoder #3 is attached to inputs #2 and #3 and used as a general purpose encoder. |
- | * Encoder #3 is attached to inputs #10 and #11 and used as a general purpose encoder. | + | |
For ET7 controller, Encoders #0 and #1 are connected to the X4 connector pins 11-14 (or through the ET7-KEY keyboard) and are configured despite being disabled in the myCNC settings window. | For ET7 controller, Encoders #0 and #1 are connected to the X4 connector pins 11-14 (or through the ET7-KEY keyboard) and are configured despite being disabled in the myCNC settings window. | ||
Line 76: | Line 75: | ||
To change Spindle speed, the XML Item " | To change Spindle speed, the XML Item " | ||
- | {{hardware:et7:mycnc-profiles--43.png}} | + | {{:mycnc:calibrate-axes-003.png}} |
A further selection of commonly used Items can be found in the [[mycnc: | A further selection of commonly used Items can be found in the [[mycnc: |
mycnc/rotary_encoder_connection_and_setup.txt · Last modified: 2022/03/22 13:49 by ivan