mycnc:rotary_encoder_connection_and_setup
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:rotary_encoder_connection_and_setup [2019/11/05 15:27] – ivan | mycnc:rotary_encoder_connection_and_setup [2019/11/07 11:41] – ivan | ||
---|---|---|---|
Line 121: | Line 121: | ||
\\ | \\ | ||
- | =====Encoder setup - closed-loop ===== | + | =====Closed-loop setup===== |
+ | |||
+ | //Read more about the topic in the [[mycnc: | ||
The following window is available upon navigating to Settings > Config > Hardware > Encoders: | The following window is available upon navigating to Settings > Config > Hardware > Encoders: |
mycnc/rotary_encoder_connection_and_setup.txt · Last modified: 2022/03/22 13:49 by ivan