mycnc:rotary_encoder_connection_and_setup
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
mycnc:rotary_encoder_connection_and_setup [2019/11/07 08:40] – ivan | mycnc:rotary_encoder_connection_and_setup [2019/11/07 11:41] – ivan | ||
---|---|---|---|
Line 122: | Line 122: | ||
\\ | \\ | ||
=====Closed-loop setup===== | =====Closed-loop setup===== | ||
+ | |||
+ | //Read more about the topic in the [[mycnc: | ||
The following window is available upon navigating to Settings > Config > Hardware > Encoders: | The following window is available upon navigating to Settings > Config > Hardware > Encoders: |
mycnc/rotary_encoder_connection_and_setup.txt · Last modified: 2022/03/22 13:49 by ivan