mycnc:server_api
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:server_api [2019/10/22 11:54] – ivan | mycnc:server_api [2019/10/22 12:42] – ivan | ||
---|---|---|---|
Line 36: | Line 36: | ||
====Server API, Pendant control emulation==== | ====Server API, Pendant control emulation==== | ||
- | Server API has a command to simplify Pendant control emulation. This command can be used for writing third-patry Pendant control device drivers. | + | Server API has a command to simplify Pendant control emulation. This command can be used for writing third-party Pendant control device drivers. |
==SetPendant== | ==SetPendant== | ||
Line 126: | Line 126: | ||
===Manipulation through PLC procedure=== | ===Manipulation through PLC procedure=== | ||
- | Server API command " | + | Server API command " |
==M62== | ==M62== | ||
Line 204: | Line 204: | ||
===Manipulation through running G-codes=== | ===Manipulation through running G-codes=== | ||
- | Server API command " | + | Server API command " |
//M-code:// '' | //M-code:// '' | ||
Line 232: | Line 232: | ||
The following videos show examples of using the server API to control a myCNC system (older versions of the software are used, however the principle is the same): | The following videos show examples of using the server API to control a myCNC system (older versions of the software are used, however the principle is the same): | ||
+ | |||
ProgramFileOpen and SetScale: | ProgramFileOpen and SetScale: | ||
{{youtube> | {{youtube> | ||
+ | |||
Hardware Binary Outputs: | Hardware Binary Outputs: | ||
{{youtube> | {{youtube> | ||
+ | |||
Set Scale and Rotation Angle: | Set Scale and Rotation Angle: | ||
{{youtube> | {{youtube> | ||
+ | |||
{{youtube> | {{youtube> | ||
+ | |||
{{youtube> | {{youtube> | ||
mycnc/server_api.txt · Last modified: 2022/09/07 15:33 by ivan