Differences

This shows you the differences between two versions of the page.

--- mycnc:server_api [2019/10/22 11:52] – ivan
+++ mycnc:server_api [2019/10/22 12:18] – ivan
@@ Line 204: / Line 204: @@
 ===Manipulation through running G-codes===
-Server API command "SinglePlay" will run a G-code line (or a number of G-code lines separated by the ";" symbol). It's possible to control binary outputs by running M-functions "M62", "M63". P-parameter set binary output number to control.
+Server API command "SinglePlay" will run a G-code line (or a number of G-code lines separated by the ";" symbol). It's possible to control binary outputs by running M-functions "M62" and "M63" (similar to the method described above). P-parameter sets the binary output number to control.
 //M-code:// ''M62''
@@ Line 231: / Line 231: @@
 ====Demo Videos====
-The following videos show examples of using the server API to control a myCNC system:
+The following videos show examples of using the server API to control a myCNC system (older versions of the software are used, however the principle is the same):
+ProgramFileOpen and SetScale:
 {{youtube>YCdr2c1h7oQ?large}}
+Hardware Binary Outputs:
 {{youtube>qpqO_GtkMmw?large}}
+Set Scale and Rotation Angle:
 {{youtube>HkDjF57dHyI?large}}
 {{youtube>gp3_o0j6eEI?large}}
 {{youtube>eocoQ7mqsCc?large}}