Differences

This shows you the differences between two versions of the page.

--- mycnc:server_api [2019/10/22 12:18] – ivan
+++ mycnc:server_api [2019/10/22 12:42] – ivan
@@ Line 36: / Line 36: @@
 ====Server API, Pendant control emulation====
-Server API has a command to simplify Pendant control emulation. This command can be used for writing third-patry Pendant control device drivers.
+Server API has a command to simplify Pendant control emulation. This command can be used for writing third-party Pendant control device drivers.
 ==SetPendant==
@@ Line 126: / Line 126: @@
 ===Manipulation through PLC procedure===
-Server API command "RunPLC" loads and runs PLC procedure on the controller end with a given parameter. We can run a PLC procedure that manipulates Hardware outputs to get a similar result. Normally every profile configuration contains PLC procedures for Hardware outputs manipulation :
+Server API command "RunPLC" loads and runs PLC procedure on the controller end with a given parameter. We can run a PLC procedure that manipulates Hardware outputs to get a similar result. Normally, every profile configuration contains PLC procedures for Hardware outputs manipulation:
 ==M62==