User Tools

Site Tools


mycnc:server_api

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
mycnc:server_api [2019/10/22 12:18]
ivan
mycnc:server_api [2019/10/22 12:42] (current)
ivan
Line 36: Line 36:
 ====Server API, Pendant control emulation==== ====Server API, Pendant control emulation====
  
-Server API has a command to simplify Pendant control emulation. This command can be used for writing third-patry Pendant control device drivers.+Server API has a command to simplify Pendant control emulation. This command can be used for writing third-party Pendant control device drivers.
  
 ==SetPendant== ==SetPendant==
Line 126: Line 126:
 ===Manipulation through PLC procedure=== ===Manipulation through PLC procedure===
  
-Server API command "​RunPLC"​ loads and runs PLC procedure on the controller end with a given parameter. We can run a PLC procedure that manipulates Hardware outputs to get a similar result. Normally every profile configuration contains PLC procedures for Hardware outputs manipulation :+Server API command "​RunPLC"​ loads and runs PLC procedure on the controller end with a given parameter. We can run a PLC procedure that manipulates Hardware outputs to get a similar result. Normallyevery profile configuration contains PLC procedures for Hardware outputs manipulation:​
  
 ==M62== ==M62==
mycnc/server_api.txt ยท Last modified: 2019/10/22 12:42 by ivan