mycnc:servo_on_off
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| mycnc:servo_on_off [2019/10/21 14:38] – ivan | mycnc:servo_on_off [2019/10/21 14:54] – ivan | ||
|---|---|---|---|
| Line 5: | Line 5: | ||
| ---- | ---- | ||
| - | The Servo ON and Servo OFF commands allow the user to create an automatic PID ON/OFF (for example, when opening/ | + | The Servo ON and Servo OFF commands allow the user to create an automatic PID ON/OFF (for example, when opening/ |
| - | The automatic turning on and off of the servo motor on software start/close can be done by going into Settings > Config > PLC > Software PLC and creating %%__HANDLER.INIT%% and %%__HANDLER_EXIT%% files (if they do not yet exist) with the following code: | + | The automatic turning on and off of the servo motor on software start/close can be done by going into Settings > Config > PLC > Software PLC and creating %%__HANDLER.INIT%% and %%__HANDLER_EXIT%% files (if they do not yet exist) with the following code: |
| <code c __HANDLER_INIT.PLC> | <code c __HANDLER_INIT.PLC> | ||
mycnc/servo_on_off.txt · Last modified: 2021/06/04 15:40 by ivan