User Tools

Site Tools


mycnc:tangential_knife_support

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
Next revisionBoth sides next revision
mycnc:tangential_knife_support [2018/08/28 21:37] skirillovmycnc:tangential_knife_support [2018/08/28 21:39] skirillov
Line 27: Line 27:
  
  
-The #7005 variable can be set in Software PLC, "____HANDLER_INIT.plc".+The #7005 variable can be set in Software PLC, "HANDLER_INIT.plc".
  
-Software PLC procedure __HANDLER_INIT is running at the start of myCNC control software right after a complete configuration sent to the controller.+Software PLC procedure HANDLER_INIT is running at the start of myCNC control software right after a complete configuration sent to the controller.
  
 It's very easy to add a line to set the variable 7005 -  It's very easy to add a line to set the variable 7005 - 
mycnc/tangential_knife_support.txt · Last modified: 2023/01/09 11:26 by ivan

Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki