mycnc:tangential_knife_support
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
mycnc:tangential_knife_support [2018/08/28 21:39] – skirillov | mycnc:tangential_knife_support [2023/01/09 11:26] (current) – ivan | ||
---|---|---|---|
Line 1: | Line 1: | ||
===== Tangential knife (Oscillating knife) control in myCNC ===== | ===== Tangential knife (Oscillating knife) control in myCNC ===== | ||
+ | |||
+ | //NOTE: This article is superseced by the newer manual on tangential cutting control: [[quickstart: | ||
+ | |||
+ | ---- | ||
myCNC software has built-in features for tangential knife control. | myCNC software has built-in features for tangential knife control. | ||
Line 27: | Line 31: | ||
- | The #7005 variable can be set in Software PLC, "____HANDLER_INIT.plc". | + | The #7005 variable can be set in Software PLC, "HANDLER_INIT.plc". |
- | Software PLC procedure | + | Software PLC procedure |
It's very easy to add a line to set the variable 7005 - | It's very easy to add a line to set the variable 7005 - |
mycnc/tangential_knife_support.txt · Last modified: 2023/01/09 11:26 by ivan