Differences

This shows you the differences between two versions of the page.

--- mycnc:teamviewer_reset_config [2017/11/22 22:31] – skirillov
+++ mycnc:teamviewer_reset_config [2017/11/22 23:50] – skirillov
@@ Line 1: / Line 1: @@
 ===== Teamviewer Reset Config =====
-If you create disk (microSD card content) from image with preinstalled Teamviewer software it may have identical Teamviewer ID. If several computers with identical ID connected to Internet it might e a problem to connect to particular Computer via Teamviewer.
+If you create disk (microSD card content) from image with preinstalled Teamviewer software it may have identical with someone else's Teamviewer ID. If several computers with identical ID are connected to the Internet it might be a problem to connect to particular Computer via Teamviewer.
-To solve this problem you need to reset Teamviewer configuration. Teamviewer with clear configuration will obtain from Teamviewer servers a new unique ID.
+To solve this problem you need to reset Teamviewer configuration. Teamviewer with empty configuration will obtain new unique ID from Teamviewer servers.
 Below there is sequence to obtain new Teamviewer ID
@@ Line 13: / Line 13: @@
 {{odroid:mycnc-odroid-howto-0-6.png}}
- * There is the only file **global.conf**;
+  * There is the only file **global.conf**;
- * Press right mouse button on it and select **Open as Administrator**;
+  * Press right mouse button on it and select **Open as Administrator**;
 {{odroid:mycnc-odroid-howto-0-7.png}}
- * Remove all content of the file and **Save** the changes;
+  * Remove all content of the file and **Save** the changes;
 {{odroid:mycnc-odroid-howto-0-8.png}}
   * Restart Teamviewer (press "Teamviewer STOP" icon, then "Teamviewer START");
-  * Accept Teamviewer EULA and check if new D is assigned
 {{odroid:mycnc-odroid-howto-0-9.png}}
+  * Accept Teamviewer EULA and check if new ID is assigned