mycnc:timers
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
mycnc:timers [2018/05/07 11:03] – skirillov | mycnc:timers [2022/03/07 16:09] (current) – ivan | ||
---|---|---|---|
Line 1: | Line 1: | ||
===== myCNC Timers ===== | ===== myCNC Timers ===== | ||
+ | |||
+ | {{youtube> | ||
myCNC controllers support up to 4 timers. | myCNC controllers support up to 4 timers. | ||
Line 9: | Line 11: | ||
myCNC software configuration dialog to setup Timers is shown below | myCNC software configuration dialog to setup Timers is shown below | ||
- | {{mycnc:mycnc-configuration-timers-001.png}} | + | {{:mycnc: |
==== Global Variable Registers to control myCNC Timers ==== | ==== Global Variable Registers to control myCNC Timers ==== |
mycnc/timers.1525705386.txt.gz · Last modified: 2018/05/07 11:03 by skirillov