Differences

This shows you the differences between two versions of the page.

--- mycnc:touch_screen_calibration_for_tinkerboard_xfce_window_manager [2018/03/31 14:48] – created skirillov
+++ mycnc:touch_screen_calibration_for_tinkerboard_xfce_window_manager [2018/05/11 12:22] (current) – skirillov
@@ Line 5: / Line 5: @@
 {{tinker:mycnc-tinker--12.png}}
-. Open Network settings in editor with Administrator permissions. Type in the konsole
+. Run **xinput_calibrator** in the konsole. Type in the konsole
-<code>sudo  mcedit  /etc/network/interfaces</code> and press Enter.
+<code>xinput_calibrator</code> and press Enter.
-{{tinker:mycnc-tinker--16.png}}
+{{tinker:mycnc-tinker--19.png}}
-{{tinker:mycnc-tinker--17.png}}
+{{tinker:mycnc-tinker--20.png}}
+. Follow instructions and Tap the red crosses to make calibration. After calibration done the **xinput_calibrator** will offer new calibration data to add to the system calibration settings
+{{tinker:mycnc-tinker--22.png}}
+Calibration settings should be saved into file **/etc/X11/xorg.conf.d/99-calibration.conf**
+. Open new konsole window. Open file **/etc/X11/xorg.conf.d/99-calibration.conf** with administrator permissions from  Editor. <code>sudo  mcedit /etc/X11/xorg.conf.d/99-calibration.conf</code>
+{{tinker:mycnc-tinker--23.png}}
+{{tinker:mycnc-tinker--24.png}}
+. Copy Calibration settings from **xinput_calibrator** output to the Editor window.
+{{tinker:mycnc-tinker--25.png}}
+. Press **F2**, **Enter** to save the settings. Reboot computer to aplly the changes.
+{{tinker:mycnc-tinker--26.png}}