mycnc:triggers
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
mycnc:triggers [2018/10/15 15:29] – pupalaiser | mycnc:triggers [2018/10/15 15:30] – pupalaiser | ||
---|---|---|---|
Line 4: | Line 4: | ||
The trigger as a function is faster than the usual input processing inside the plc procedure. | The trigger as a function is faster than the usual input processing inside the plc procedure. | ||
A striking example of the work of the trigger is the work of the sensor "arc response" | A striking example of the work of the trigger is the work of the sensor "arc response" | ||
- | Therefore, this sensor is most convenient to handle using a trigger. | + | * Therefore, this sensor is most convenient to handle using a trigger. |
- | Therefore, this sensor is most convenient to handle using a trigger. | + | |
myCNC software supports up to 4 Triggers. | myCNC software supports up to 4 Triggers. | ||
* It's possible to configure **Input Number** and **Edge Type** (Rising or Falling) to activate the Trigger. | * It's possible to configure **Input Number** and **Edge Type** (Rising or Falling) to activate the Trigger. |
mycnc/triggers.txt · Last modified: 2022/03/07 16:09 by ivan