Differences

This shows you the differences between two versions of the page.

--- mycnc:wireless_pendants [2019/07/26 10:41] – ivan
+++ mycnc:wireless_pendants [2019/07/26 10:43] – ivan
@@ Line 73: / Line 73: @@
 | Pendant0: x0.001-1 | Sets the increment for the machine movements which is controlled by the pendant |
 | Pendant0: Axis off |  |
-| Pendant0: Axis X-C |  |
+| Pendant0: Axis X-C | Sets the axis that the pendant will be sending commands to |
 | Pendant: Work coordinate Half | Takes the pendant work coordinate (in the axis specified on the pendant) and halves it |
 | Pendant: Work coordinate Reset | Resets the work coordinate specified in the pendant axis |
@@ Line 79: / Line 79: @@
 | PLC: Run external unit procedure | Run a PLC procedure on a slave controller. The syntax for the command will be as follows: controller number / command / variable (for example, 0x01/M74/#7009) |
 | Run Numpad |  |
-| Show: Pendant control widget |  |
+| Show: Pendant control widget | Brings up the pendant control widget in the myCNC software |
 | Select axis | Select the particular axis |
 | Show: Widget | Shows a particular widget, such as Library Shape, Diagnostics, Config, etc |