mycnc:wireless_pendants
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
mycnc:wireless_pendants [2019/07/26 11:50] – ivan | mycnc:wireless_pendants [2019/07/26 12:13] – ivan | ||
---|---|---|---|
Line 28: | Line 28: | ||
| File: Open DXF/HPGL | Open a DXF/HPGL file from the folders specified in Preferences > Common | | | File: Open DXF/HPGL | Open a DXF/HPGL file from the folders specified in Preferences > Common | | ||
| File: Refresh | Refresh the program file | | | File: Refresh | Refresh the program file | | ||
- | | Hardware: Direct Binary Set | | | + | | Hardware: Direct Binary Set | Directly sets a binary to be ON | |
- | | Hardware: Direct Binary Clear | | | + | | Hardware: Direct Binary Clear | Sets a binary to be OFF | |
- | | Hardware: Direct DAC Set | | | + | | Hardware: Direct DAC Set | Sets the DAC | |
- | | Hardware: Direct PWM Set | | | + | | Hardware: Direct PWM Set | Sets the Pulse Width Modulation |
| Hide: Custom Widget by name | Hide the custom widget | | | Hide: Custom Widget by name | Hide the custom widget | | ||
| Job: Play 1 line | Run through a single command line (next line) | | | Job: Play 1 line | Run through a single command line (next line) | |
mycnc/wireless_pendants.txt · Last modified: 2022/08/19 15:22 by ivan