mycnc:wireless_pendants
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:wireless_pendants [2019/07/26 15:01] – ivan | mycnc:wireless_pendants [2019/10/31 13:08] – ivan | ||
---|---|---|---|
Line 11: | Line 11: | ||
* The indicators at the top of the page serve to visually point out the pendant button which is being pressed. There indicators will light up green when the corresponding button is pressed: | * The indicators at the top of the page serve to visually point out the pendant button which is being pressed. There indicators will light up green when the corresponding button is pressed: | ||
{{: | {{: | ||
- | * DSP style pendant should be disabled if the controller is used with a screen. This setting, when set to PHB-04B disables a number of on-screen buttons as well as blocks | + | * DSP style pendant should be disabled if the controller is used with a screen |
* The Device List lists the available devices, while the libUSB Debug information lists the messages that the pendant sends to the computer: | * The Device List lists the available devices, while the libUSB Debug information lists the messages that the pendant sends to the computer: | ||
{{: | {{: | ||
* It is possible to load the default button configurations from some of the popular wireless pendants available, as listed on the right side of the screen: | * It is possible to load the default button configurations from some of the popular wireless pendants available, as listed on the right side of the screen: | ||
{{: | {{: | ||
- | * If the pendant used is not listed in the defaults list, or the user wants to re-assign some of the button actions, the following options are available: | + | |
+ | ===Assignable actions=== | ||
+ | |||
+ | If the pendant used is not listed in the defaults list, or the user wants to re-assign some of the button actions, the following options are available: | ||
^ Option ^ Description ^ | ^ Option ^ Description ^ | ||
Line 39: | Line 42: | ||
| Job: Skip backward | Move backward in the command program | | | Job: Skip backward | Move backward in the command program | | ||
| Job: Skip forward 10 | Skip 10 lines forward | | | Job: Skip forward 10 | Skip 10 lines forward | | ||
- | | Job: Skip backward 10 | Skip 10 lines backwar000000000000000d | + | | Job: Skip backward 10 | Skip 10 lines backward |
| Jog: X- | Jog in the negative x-axis direction | | | Jog: X- | Jog in the negative x-axis direction | | ||
| Jog: X+ | Jog in the positive x-axis direction | | | Jog: X+ | Jog in the positive x-axis direction | |
mycnc/wireless_pendants.txt · Last modified: 2022/08/19 15:22 by ivan