Differences

This shows you the differences between two versions of the page.

--- mycnc:wireless_pendants [2019/07/26 13:58] – ivan
+++ mycnc:wireless_pendants [2019/08/12 09:17] – ivan
@@ Line 11: / Line 11: @@
   * The indicators at the top of the page serve to visually point out the pendant button which is being pressed. There indicators will light up green when the corresponding button is pressed:
 {{:mycnc:hardware-pendants-002-indicators.png}}
-  * DSP style pendant should be disabled if the controller is used with a screen. This setting, when set to PHB-04B disables a number of on-screen buttons as well as blocks a few of the pendant commands. It is recommended to keep this setting disabled unless strictly necessary.
+  * DSP style pendant should be disabled if the controller is used with a screen. This setting, when set to PHB-04B disables a number of on-screen buttons as well as blocks a few of the pendant commands. It is recommended to keep this setting disabled unless strictly necessary, as it is designed for a purely pendant-oriented interface.
   * The Device List lists the available devices, while the libUSB Debug information lists the messages that the pendant sends to the computer:
 {{:mycnc:hardware-pendants-004-debug.png}}
@@ Line 39: / Line 39: @@
 | Job: Skip backward | Move backward in the command program |
 | Job: Skip forward 10 | Skip 10 lines forward |
-| Job: Skip backward 10 | Skip 10 lines backwar000000000000000d |
+| Job: Skip backward 10 | Skip 10 lines backward |
 | Jog: X- | Jog in the negative x-axis direction |
 | Jog: X+ | Jog in the positive x-axis direction |
@@ Line 70: / Line 70: @@
 | Pendant: Axis change + | Changes the axis to the next axis available |
 | Pendant: Axis change - | Changes the axis to the previous axis available |
-| Pendant0: x0.001-1 | Sets the increment for the machine movements which is controlled by the software pendant (older versions of the software have a pendant widget) |
+| Pendant0: x0.001-1 | Sets the increment for the machine movements which is controlled by the software pendant (older versions of the software have a pendant widget which can be used as a substitute for a pendant control) |
-| Pendant0: Axis off |  |
+| Pendant0: Axis off | This turns off the selected axis in the software pendant widget (older version of the software) |
 | Pendant0: Axis X-C | Sets the axis that the software widget pendant will be sending commands to |
 | Pendant: Work coordinate Half | Takes the pendant work coordinate (in the axis specified on the pendant) and halves it |
@@ Line 96: / Line 96: @@
 | Toggle Spindle CCW on/off | Toggle the spindles CCW rotation ON or OFF |
 | Toggle Constant Velocity on/off | CV (constant velocity) is described in [[mycnc:constant_velocity_mode_cv|MyCNC Constant Velocity Mode (CV)]] manual |
-| Toggle Virtual Keyboard | Brings up the virtual keyboard up on the screen, or hides it if already present |
+| Toggle Virtual Keyboard | Brings up the virtual keyboard up on the screen, or hides it if already present. |
 | Toggle: custom widget by name | Specifies a custom widget to bring up on the screen (or close it if already displayed). |
 | View: Zoom In | Zoom in on the control program visualization |