mycnc:wireless_pendants
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
mycnc:wireless_pendants [2019/08/19 15:07] – ivan | mycnc:wireless_pendants [2019/10/31 13:08] – ivan | ||
---|---|---|---|
Line 11: | Line 11: | ||
* The indicators at the top of the page serve to visually point out the pendant button which is being pressed. There indicators will light up green when the corresponding button is pressed: | * The indicators at the top of the page serve to visually point out the pendant button which is being pressed. There indicators will light up green when the corresponding button is pressed: | ||
{{: | {{: | ||
- | * DSP style pendant should be disabled if the controller is used with a screen. This setting, when set to PHB-04B disables a number of on-screen buttons as well as blocks | + | * DSP style pendant should be disabled if the controller is used with a screen |
* The Device List lists the available devices, while the libUSB Debug information lists the messages that the pendant sends to the computer: | * The Device List lists the available devices, while the libUSB Debug information lists the messages that the pendant sends to the computer: | ||
{{: | {{: |
mycnc/wireless_pendants.txt · Last modified: 2022/08/19 15:22 by ivan