Differences

This shows you the differences between two versions of the page.

--- mycnc:wireless_pendants [2020/03/12 13:54] – ivan
+++ mycnc:wireless_pendants [2020/05/05 10:00] – ivan
@@ Line 1: / Line 1: @@
- =====Wireless Pendants=====
+=====Wireless Pendants=====
 Wireless pendants are currently sold in three configurations in the myCNC Shop.
@@ Line 38: / Line 38: @@
 | Job: Play 1 line | Run through a single command line (next line) |
 | Job: Play 1 line backwards | Run through a single command line (previous line) |
-| Job: Back to path | Run a predefined G-code command |
+| Job: Run G-code | Run a predefined G-code command (the command must be written out in the Message slot) |
-| Job: Back to path | Run a predefined G-code after confirming via a confirmation window.  |
+| Job: Run G-code with Confirmation | Run a predefined G-code after confirming via a confirmation window (the G-code command must be written out in the Message slot).  |
+| Job: Start running | Begin running the control program code  |
+| Job: Stop running | Stop the control program |
+| Job: Back to path | Run the back to path procedure - described [[mycnc:mycnc_configuration_dialogs#back_to_path|here]] |
 | Job: Skip forward | Move forward in the command program |
 | Job: Skip backward | Move backward in the command program |
@@ Line 112: / Line 115: @@
 These options allow the user to edit every button on their pendant control to their particular configuration if required. For simple pendants included in the defaults list, it is usually recommended to use the default settings.
+====XHC wireless pendant control for MS Windows====
+How to install XHC wireless pendant control for MS Windows:
+. Download the "Zadig" software from  http://zadig.akeo.ie/
+{{:mycnc:pendant-001-windows.png?}}
+. Run the utility, select "Options menu" and check menu "List All Devices"
+{{:mycnc:pendant-002-windows.png}}
+. Select "USB HID" device  in the displayed list (Check USB ID that starts with "10CE")
+{{:mycnc:pendant-003-windows.png}}
+The following ID's are available:
+^ ID ^ Pendant Model ^
+| eb66 |  |
+| eb6f | PHB02, WHB02 |
+| eb93 | WHB04B-6 |
+| eb92 | PHB02B-6 |
+| eb91 | PHB04B-6 |
+| eb70 | WHB04L |
+. Select "WinUSB" driver and press "Replace Driver" button, confirm driver changes.
+. Restart myCNC software, it should get access to XHC Pendant control over "libusb" driver.